lost config of mesh with omada controler

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

lost config of mesh with omada controler

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
lost config of mesh with omada controler
lost config of mesh with omada controler
2022-05-16 21:02:01 - last edited 2022-05-17 00:52:39

Hello

 

I did configure a Mesh with 4 EAP Access points at home. The Omada Controler was installed on my computer. This computer crashed and was reset. I've lost all the config of the Mesh

When I install a new Omada controler, I can see 3 of the 4 AP, but I cannot "adopt" them.

the Log entry only say it failed

 

When I try to connect to the AP directly using the IP address, it is not reachable.

 

what do you suggest? Reset of all AP?

 

thank you

Vincent

  0      
  0      
#1
Options
1 Reply
Re:lost config of mesh with omada controler
2022-05-16 22:30:41 - last edited 2022-05-17 00:52:39

  @dudu.orp 

 

Check this thread for a similar case.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 373

Replies: 1

Related Articles