No Antenna signal

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

No Antenna signal

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
No Antenna signal
No Antenna signal
2022-08-01 10:31:13 - last edited 2022-08-02 01:05:35
Model: CPE210  
Hardware Version: V3
Firmware Version:

can anyone help. I have installed the extender through the admin panel. I used the quick set-up and can see the antenna. It seems that maybe the antenna signal is defect. The antenna was set-up in Repeater mode. The power and LAN lights are flashing. The signal lights are not on at all

 

Thank you

  0      
  0      
#1
Options
1 Reply
Re:No Antenna signal
2022-08-02 08:15:14

  @MarcThomas 

 

Check this:

 

Actually, CPE is equipped with directional antenna as it is designed for point-to-point long-distance network transmission, its wireless signal is mainly focused on its front panel and has a very limited 60 degree angle, we can say that there is almost no signal on its side and back panel. If you use it on repeater mode, the performance may not be so good, and it requires that both the front-end Internet source device and client device should be all within cpe wifi angle.
You can refer this link to see cpe wifi angle:
https://www.tp-link.com/support/faq/1044/

Just striving to develop myself while helping others.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 440

Replies: 1

Related Articles