Business Community > All Threads > STP Configuration
< All Threads

STP Configuration

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

STP Configuration

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
STP Configuration
STP Configuration
2022-09-15 02:56:04
Model: T2600G-52TS(TL-SG3452)  
Hardware Version: V2
Firmware Version: 2.0.0 Build 20170323

I am attempting to confirm that I have STP properly configured with the following tp-link switches.

T2600G-52TS - Primary Switch - CIST Priority = 4096  (SONOS Music Players and Zappiti Media Players)

T2600G-28TS - Remote Switch #1 - CIST Priority = 8192 (SYNOLOGY DS1821+ NAS - Music and Movie Files)

TT2500G-10T - Remote Switch #2 - CIST Priority = 8192

 

TL-SG3210 - Remote Switch #3 - CIST Priority = 8192

1. SONOS requires STP which I have configured on all switches.

2. All switch ports that connected to the SONOS components are configured with STP Enabled and STP Path Cost = 10.

3. All interlink tp-link switch ports between the Primary and Remote Switches have STP Enabled and STP Patch Cost = 4.

4. All ports that have equipment connected that do NOT require STP have STP disabled in the switch configuration.

5. I have the CIST Priority configured as listed above. My goal is to insure that the T2600G-52TS is the ROOT BRIDGE. I am not sure if I have the CIST Priority configured correctly on the Remote Switches. Should each switch have a different priority.

 

I look forward to comments and suggestions about my configuration.

 

  0      
 
  0      
 
#1
Options
2 Reply
Re:STP Configuration
2022-12-13 17:36:30

  @PLCMAN58 

 

It's hard to say without information on the topology.

if all remote switches are only connected to the primary switch it will work.

 

If e.g. the remote switch #3 is connected to #1 and #2 (and #1 and #2 connected directly or via primary switch) the setup is not optimal, because all remote switches have the same priority.

 

Also, the path costs seem to be very low. Standard values are 200000 for 100Mbit, 20000 for Gigabit and 2000 for 10G links. If you keep your settings consistent, it's fine, but the switches also allow automatic setting of the costs and then your numbers might result in a less efficient setup.

  0  
  0  
#2
Options
Re:STP Configuration
2022-12-17 23:18:04
Yes, all of the remote switches are directly connected to the T2600G-52TS which is the primary Ethernet Switch. The path costs are low since the SONOS hardware uses are older STP standard. The suggested path costs have been provided by them.
  0  
  0  
#3
Options

Information

Helpful: 0

Views: 782

Replies: 2

Related Articles
T2600G-52TS - STP Edge Port Configuration
1345 0
SSL configuration on T2600G-52TS 3.0
2205 0
802.1x port configuration uplink (supplicant for another switch)
2721 0
Is there's a video tutorial for basic configuration of TP Link switch?
708 0
Multiple STP
423 0
IP from the DHCP serwer
481 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.