Hello,

I've recently installed Starlink at our property and purchased 2 of the CPE710's to bring the network into our house.  I had to install the Starlink dish several hundred feet from the house in order to be clear of obstruction and have placed the starlink router securely in the barn.  I have the Access Point unit connected to the starlink router via the Starlink ethernet adapter, the client is set about 250 feet from the AP, and is run into the house via POE cat6.  On the LAN side, I run and ASUS router for a work network, and then into an Orbi Mesh Network for the rest of the house.

After some early double NAT issues, I believe it is all set up correctly.  Starlink --> CPE710 AP --> CPE710 Client --> Asus Router --> Orbi Mesh

If I head into the barn and run the speed test via the Starlink App from the Starlink wifi, I'm seeing 21 down, 4.1 up and 78ms latency.  Not great by starlink numbers by any means but there are lots of clouds and rain today so perhaps that has something to do with it.  I have seen up to 50 down so far, as it's only been up and running for about 24 hours.

In the house is where things go from mediocre to pretty awful, 5-8 down, 0.11 up and 103 ms latency.  I'm thinking it has something to do with the setup on the CPE710s.  Other than setup, the AP is under the eve of the barn which has a metal roof, could that be interruping the signal and causing the especially poor upload figures?

I ran the antenna alignment tool, seems ok.  Since the AP and Client are relatively close, I have everything else set to auto.  Anything I should be looking at in the Pharos app that can help me troubleshoot this?

Thank you