Omada OC200 > Wired Networks > LAN Also Gateway

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Omada OC200 > Wired Networks > LAN Also Gateway

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Omada OC200 > Wired Networks > LAN Also Gateway
Omada OC200 > Wired Networks > LAN Also Gateway
2022-10-06 10:53:35 - last edited 2022-10-06 11:53:36
Model: OC200  
Hardware Version:
Firmware Version: V5.5.7

I am a bit confused on the LAN setting in the OC200 Hardware Controller.

 

I plugged the OC200 into one of the modem / routers ports.

It adopted without issue.

All APs are adopted and connected.

Internet is working.

 

What exactly is the LAN setting referring to in the Omada Controller?

It shows 192.168.0.1/24. Did it auto-detect my modem because that is the LAN address of the modem or is that a setting I should change so it is different than the modems IP?

The OC200 is obviously getting assigned an IP from the Modem so I am unclear what this setting is and if I need to address it.

 

When I edit that entry in LAN it has a yellow prompt next to interface that says (Gateway Required).

  0      
  0      
#1
Options
1 Reply
Re:Omada OC200 > Wired Networks > LAN Also Gateway
2022-10-18 12:11:36

  @RickJamesBish 

 

If you don't have a Omada Gateway, you don't need to care about that.

Like the prompt saying: Gateway Required, you need to use or change it if you have a Omada router managed by OC200.

Just striving to develop myself while helping others.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 531

Replies: 1

Related Articles