EAP225 Outdoor RX TX Dropped Errors Retry
Not sure but these numbers seem quite high. I recall reading that there was an issue with the reporting but I think it was addressed in a firmware update. What can I do to investigate this?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
I would recommend looking at the time of day... next day during that time look at the signal levels of the wireless client list.
Low signal clients can drive this graph up. May have to enable mini rssi or add an AP somewhere.
- Copy Link
- Report Inappropriate Content
@KimcheeGUN Thanks. Will do that. I already have RSSI Threshold set at -76 because I was seeing -80 clients on AP #1, when they were nearer to, and getting better RSSI, on AP #2. I also set a client limit on AP#1 in an attempt get better signals to fill that AP first, forcing lower signals to connect to AP#2 but it does not seem to work out that way. The load balancing just does not seem to work all that well.
- Copy Link
- Report Inappropriate Content
You have mini rssi set on the 2.4 or 5?
I would lower it to -70 to -73 is a good number to boot clients and force them to roam.
Also Mini Rssi isnt an exact number... Its gives a few DB each way. I always shoot a tad lower to make up for it.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 998
Replies: 3
Voters 0
No one has voted for it yet.