OC200 Controller Keeps Freezing
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
So I've been running a Cisco router and PoE Switch for the past 2 years; great speed and using OC200 and 3x EAP225s.
Unfortunately the router blew up, so I thought I'd make the full plunge to Omada setup.
I'm now running;
ER7206 (1x WAN @ 1Gb up/down)
SG2428P
OC200
3x EAP225
Managed to get everything set up OK; I actually reset the OC200 and EAPs and started again. But when I am working in the controller, either via the ip address or the https://omada.tplinkcloud.com/ I am getting constant freezing where the page doesn't load. I assume there is a drop to the network as I have also been experiencing the same on the TV when watching Youtube (both are happening with wireless connections).
Any ideas?!
Mike
p.s. Is there a way to power schedule/reboot ALL of the hardware in sequence (i.e. router and switch) other than simply unplugging?
Further to the original post; it is definitely the WiFi that is dropping (cannot confirm if the wired network is experiencing the same).
Trying to work connected via WiFi is proving difficult.
Dashboard shows the below;
When it is running, a speed test shows very poor results (vs. Cisco router and switch) everything else the same.
226Mb/s (download)
407Mb/s (upload)
I was consistently getting 500Mb/s + previously.
Any advice/suggestions would be greatly appreciated!
Mike
Further to the original post; it is definitely the WiFi that is dropping (cannot confirm if the wired network is experiencing the same).
Trying to work connected via WiFi is proving difficult.
Dashboard shows the below;
When it is running, a speed test shows very poor results (vs. Cisco router and switch) everything else the same.
226Mb/s (download)
407Mb/s (upload)
I was consistently getting 500Mb/s + previously.
Any advice/suggestions would be greatly appreciated!
Mike
