Omada didn't work properly with er605

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Omada didn't work properly with er605

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Omada didn't work properly with er605
Omada didn't work properly with er605
2023-03-21 06:45:38
Model: ER605 (TL-R605)  
Hardware Version: V2
Firmware Version: 2.1.2

Hi guys

 

Hi first of all, the router works correctly with the web configuration.

 

I'm trying to use Omada about a mounth

But I got a few problens

 

My router have the first WAN in PPPoE mode, thats fine.

Lan1 and Lan2 have the Lan 192.168.0.0

I have two mercusys mg50 connected in these ports by its Wan ports.

Each Mercusys have respectively the ip, 192.168.1.0 and 192.168.2.0 and they connect on er605 by static ip respectively 192.168.0.11 and 192.168.0.12.

I made some routers and everything works fine.

 

In the Lan3 I have a tplink managed switch with the lan 192.168.10.0, and the computer get this ip. Everything its fine.

 

The problem is the Lan4 (the last port) its has the lan 174.162.40.10 (yep I want it be weird), In the last port I have another mercusys but no matter what I do, this last mercusys didnt get the ip, even if I change to static. If I connect one pc to this port, this pc doenst get the ip, even static it doesnt work.

 

I tried all Omada v5 versions but only the version 5.8 got support to pvid. 

 

Thanks in advance

  0      
  0      
#1
Options
3 Reply
Re:Omada didn't work properly with er605
2023-03-22 03:29:53

  @drigo 

 

Did you set the last port as Tagged?

PC can not handle the tagged data if you set it like that. Change it to Untagged, and test it.

Just striving to develop myself while helping others.
  0  
  0  
#2
Options
Re:Omada didn't work properly with er605
2023-03-22 04:50:33

  @Virgo Of course I did..

As I said. The last port didnt work

It works normally using the native web gui.

With Omada nothing works properly.

I saved the config file

  1  
  1  
#3
Options
Re:Omada didn't work properly with er605
2023-03-22 04:55:35

  @Virgo The fifth port is equal the other ones, only the ip change.

Omada doenst let you to mark the vlan that you editing as tagged, If I editing vlan1 for example I can only tag other vlans.

Omada for er605 is different than Omada for switchs, I think thats your confusion

  0  
  0  
#4
Options