EAP 115 Disconnected - High Utilised
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP 115 Disconnected - High Utilised
Recently i am getting issue with 2 EAP's installed with Hight RX Frames causing EAP to disconnected and it doesn't reconnect.
i tired auto setting for channel width, channel, TX power normally its should works fine but still same issue.
tried manual configratuion.
both EAP's are in different channel. 1 and 13 (20MHZ : Channel Width) same issue.
i am guess it either issue with EAP firmware or Issue with software controller version Omada_SDN_Controller_v5.9.31_
Has anyone exprenced similar issue.