Uanble to upload the new BETA Firmware ER8411 v1.0.4

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
12

Uanble to upload the new BETA Firmware ER8411 v1.0.4

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
14 Reply
Re:Uanble to upload the new BETA Firmware ER8411 v1.0.4
2023-06-08 16:41:11
Tried 2 different browsers, re-downloaded it, connected via wifi, switch and router. OC300 running 5.9.32. No go. I will not put router in standalone mode for this.
  0  
  0  
#12
Options
Re:Uanble to upload the new BETA Firmware ER8411 v1.0.4-Solution
2023-06-08 19:18:54 - last edited 2023-06-08 19:19:04

  @crrodriguez This is the solution.

I made a backup (which I luckely didn't need).

Forgot the device, Pushed 10 seconds the reset button for factory reset. Weired my Laptop with the router directly and unwired all other devices , Opens the webpage (192.168.0.1). Enter new credentials (not forget, you need this later while adopting the device again). Upgrade the device. After restart, configured the former IP Adress of the device. Restart it again. Weired all switches and the OCS controller. Adopt the router, and that it is.

 

New frimware availabable and FINALLY AFTE LONG TERM OF WAIT AND PATIENCE. I have now a router which can use custom Dyndns Services.

 

Thanks a lot to all

 

Thorsten

Recommended Solution
  1  
  1  
#13
Options
Re:Uanble to upload the new BETA Firmware ER8411 v1.0.4
2023-06-08 19:21:34
Which FIrmware are you using? The 1.0.3 beta with the ACL fix? This was the firmware I used before?
  0  
  0  
#14
Options
Re:Uanble to upload the new BETA Firmware ER8411 v1.0.4
2023-06-09 12:29:08
I have the 1.0.3 official release in the ER8411. It seems that only way to go to the 1.0.4 beta is to put the device into standalone mode and then update and adopt again. Not the way I want to go but I guess nothing to lose :(.
  0  
  0  
#15
Options