POE camera not working when connected to POE passthrough port on EAP615-Wall(US) v1.0
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
POE camera not working when connected to POE passthrough port on EAP615-Wall(US) v1.0
I have an EAP615-Wall (US) connected to the POE port of a TL-SG2008P v3.0. The switch is showing 4.4W PoE power.
Connected to the POE passthrough port on the AP is a Reolink PoE camera (RLC-811A) which says it needs less-than 12W
This is the amount that the AP should be able to support, but it's not working. How can I get some diagnostic information on this? It works fine if I connect a powered POE switch to the AP, but running that power would be super inconvenient, and defeat the purpose of POE for me.
(and yes, I turned on ETH3 PoE Out in the AP advanced settings)