CPE510 multiple VLAN
Have 2 CPE510 devices 100ft apart, trying to pass multiple vlans set as AP and Client (below), any help I appreciate your input
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
CPE is a VLAN-Passthrough device, the image shows your CPEs are working properly, what is the issue?
- Copy Link
- Report Inappropriate Content
@Virgo I have those 2 units connected to my network and on the client side I have a TL-SG2008P 8 port switch and a EAP115(US) v4.0 AP.
The switch is adpoted but the AP will not readopt nore can you connect to the ap and get internet, I have a turned off and on the POE port the AP is connected to and turned to power off to all devices and back on, it will not adopt, only thing I have not done is move the AP to the main switch to adpopt and updat if needed, any other thoughts
- Copy Link
- Report Inappropriate Content
The switch can be adopted, but the AP can not. It proves the issue isn't on the CPE at least otherwise I don't think the switch can be managed properly.
Did you set any VLAN or ACL on the switch port? If you connect the AP to the client CPE, can it be adopted? ping the AP IP, can you ping through?
- Copy Link
- Report Inappropriate Content
@Virgo VLAN on switch is set to ALL(4 VLANs),
20.129 is the AP, 20.120 is the switch bothe on the client side
SWITCH ACL
2 - Pinter is on LAN group
3 - Pinter is on LAN group
the rest I think show their info
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1013
Replies: 6
Voters 0
No one has voted for it yet.