Help Needed: Setting Up TP-Link EAP-610 as a Repeater with Subnetwork

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Help Needed: Setting Up TP-Link EAP-610 as a Repeater with Subnetwork

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Help Needed: Setting Up TP-Link EAP-610 as a Repeater with Subnetwork
Help Needed: Setting Up TP-Link EAP-610 as a Repeater with Subnetwork
2023-11-25 15:24:22 - last edited 2023-11-30 08:01:10
Model: EAP610-Outdoor  
Hardware Version: V1
Firmware Version: 1.1.3

Hello everyone,

 

I recently purchased the TP-Link EAP-610 router and updated it to the latest firmware version 1.1.3. I've successfully set it up as a repeater to extend the Wi-Fi range from my parent's house, where the main router is located with the IP address 192.168.0.1. We're sharing the Wi-Fi network, but I'm facing a challenge in setting up a subnetwork with the TP-Link EAP-610.

 

Previously, I used a Comfast EW74, and with its repeater function, I was able to create a subnetwork with the IP range 192.168.2.X. However, I'm struggling to find the same functionality on the TP-Link EAP-610.

 

Is there a way to configure the TP-Link EAP-610 as a repeater while assigning it a different subnet, such as 192.168.2.X? I want to maintain a separate network for my devices in the back garden.

 

I've checked the router's settings, but it seems different from what I was used to with the Comfast EW74. Any guidance or step-by-step instructions would be greatly appreciated.

 

Thank you in advance for your assistance!

  0      
  0      
#1
Options
1 Accepted Solution
Re:Help Needed: Setting Up TP-Link EAP-610 as a Repeater with Subnetwork-Solution
2023-11-27 08:52:23 - last edited 2023-11-30 08:01:10

Hello @Maehooge,

 

Please note that EAP610 can not be used as DHCP Sever, you need to set the VLAN interface on the front-end router, refer to this similar FAQ.

There is a helpful post you may take a look:

Essence Posts Summary — Omada Configuration Videos (VPN, VLAN, ACL-Related)

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  1  
  1  
#2
Options
1 Reply
Re:Help Needed: Setting Up TP-Link EAP-610 as a Repeater with Subnetwork-Solution
2023-11-27 08:52:23 - last edited 2023-11-30 08:01:10

Hello @Maehooge,

 

Please note that EAP610 can not be used as DHCP Sever, you need to set the VLAN interface on the front-end router, refer to this similar FAQ.

There is a helpful post you may take a look:

Essence Posts Summary — Omada Configuration Videos (VPN, VLAN, ACL-Related)

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  1  
  1  
#2
Options

Information

Helpful: 0

Views: 1236

Replies: 1

Related Articles