0
Votes

EAP245 Set Device Name in Standalone Mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
 
0
Votes

EAP245 Set Device Name in Standalone Mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP245 Set Device Name in Standalone Mode
EAP245 Set Device Name in Standalone Mode
2024-01-26 10:08:31 - last edited 2024-01-29 00:57:33

Hi there,

 

I'm using the EAP245(EU) HWV3 Firmware 5.1 access point in standalone mode. It reports its device name as EAP<MAC> and I would like to be able to change that name to match the rest of my installation (other vendor network equipment). The usage of the controller is overkill for me because you don't supply a MacOs version of it (it would mean I had to have a windows computer along). I did use the software controller to change the device name only to find out that when I make the controller forget the device, the device is also reset to factory defaults.

 

Can you allow to change the device name in standalone mode, or is there a way that I haven't seen?

 

Thank you

 

BTW: The EAP245 was not offered in the Model dropdown list.

#1
Options
3 Reply
Re:EAP245 Set Device Name in Standalone Mode
2024-01-29 06:17:17 - last edited 2024-01-29 06:18:24

Hi @donnerluetjen

 

Thank you for your valuable feedback.
I've recorded this request and will report it to the developer team for evaluation.

 

donnerluetjen wrote

BTW: The EAP245 was not offered in the Model dropdown list.

 

I can find the EAP245 in the Model dropdown list, which list did you talk about?

 

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
#2
Options
Re:EAP245 Set Device Name in Standalone Mode
2024-02-10 14:28:21 - last edited 2024-02-10 15:04:01

I was able to change my EAP610 name when using the mobile app in standalone mode. The setting screen has option to change the device name.

 

The issue still remains tho, as my DHCP still receives the name as EAP<model>-<MAC>

#3
Options
Re:EAP245 Set Device Name in Standalone Mode
2024-05-17 02:22:16

  @Stoinov did you find a way to change the DEVICE NAME in DHCP receiving?

#4
Options

Information

Helpful: 0

Views: 510

Replies: 3

Voters 0

No one has voted for it yet.