Business Community > All Threads > Is there any way to show IPv6 address in client page?
< All Threads

Is there any way to show IPv6 address in client page?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Is there any way to show IPv6 address in client page?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Is there any way to show IPv6 address in client page?
Is there any way to show IPv6 address in client page?
2024-03-13 11:13:06
Model: OC200  
Hardware Version: V1
Firmware Version: 1.29.3 Build 20240131 Rel.35531

Now that the EAP225-Outdoor Pre-release firmware supports IPv6, is there a way to display the wired client's assigned IPv6 address (both local and public) on the client page?

Those inside yellow boxes are wired clients.

Gateway: ER605 v2 2.2.4 Build 20240119 Rel.44368
Controller: OC200 v1 1.29.3 Build 20240131 Rel.35531

 

  0      
 
  0      
 
#1
Options
3 Reply
Re:Is there any way to show IPv6 address in client page?
2024-03-14 09:40:07

  @ceejaybassist 

Can you confirm whether Wired clients are assigned IPv6 addresses? Can IPv6 addresses be displayed for wireless clients? Is your router an Omada router?

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options
Re:Is there any way to show IPv6 address in client page?
2024-03-14 11:56:11 - last edited 2024-03-14 12:03:05

  @Hank21 Yes. All wired clients/devices support IPv6 (except OC200 maybe?) and I can confirm that they are getting an IPv6 address. However, their IPv6 address is not showing in the IPv6 pane in the client page. As you can see from the photo above, only the clients connected to my EAP225-Outdoor (early access firmware) are displaying their IPv6 addresses in the IPv6 pane of the client page. My gateway is Omada ER605 v2.

  0  
  0  
#3
Options
Re:Is there any way to show IPv6 address in client page?
2024-03-20 09:58:45

  @ceejaybassist 

To better assist you, I've created a support ticket via your registered email address, and escalated it to our support engineer to look into the issue. The ticket ID is TKID240339276. please check your email box and ensure the support email is well received. Thanks!

Once the issue is addressed or resolved, welcome to update this topic thread with your solution to help others who may encounter the same issue as you did.

Many thanks for your great cooperation and patience!

 

 

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#4
Options

Information

Helpful: 0

Views: 435

Replies: 3

Related Articles
Displaying the wrong client IP Address
800 0
Wirless Client Show up as Wired -
446 0
Non-Address ipv6
1087 0
Client Activiy Speed way off (too low)
874 0
OC200 should Show as a Device instead of Client
440 13
BUG: IPv6 address of clients are NOT displayed in Omada
647 4
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.