Problem with policy routing
Problem with policy routing
Hello everyone, I have a problem with my policy routing. I have 3 ISPs (WAN, WAN/LAN1, WAN/LAN2).
I created a VLAN (123), created a wireless network with this VLAN and routed it through WAN/LAN1.
At the moment, my WAN/LAN1 is offline, it should be, and I expect that there should be no Internet on my wireless network (VLAN123), because it is redirected through the WAN/LAN1 port, but the Internet works through WAN, or through WAN/LAN2, if WAN does not work.
Use the other WAN port, this checkbox is not selected.
The same problem with VLAN124 and the WAN/LAN2 port.
Load balancing has this setting
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi @Hank21,
I ran some tests as you asked, in this case my WAN/LAN1 is offline, I am connected to a test WIFI which should only work through WAN/LAN1 according to the policy routing. But I have access to the Internet via WAN/LAN2.
- Copy Link
- Report Inappropriate Content
Hi @Hank21
today I did some more tests, and noticed that when WAN/LAN1 is offline, but has an IP address other than 0.0.0.0, then all the policy routing rules work as expected.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1206
Replies: 12
Voters 0
No one has voted for it yet.