TL-R470T+ Load Balance Stop Working
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-R470T+ Load Balance Stop Working
Region : Argentina
Model : TL-R470T+
Hardware Version : V3
Firmware Version :
ISP :
TL-R470T+ Load Balance Stop Working after 3 Days
I didn't change any settings it just refust to pull anything from WAN2.. I Swapped and it didn't want to pull from WAN1..
All my settings are static since I'm pulling from over a WiFi WAN
The only settings I put into the router was the 2 WAN Addresses and Adance>Load Balance Take the Tick Off Enable Application Optimized Routing
Model : TL-R470T+
Hardware Version : V3
Firmware Version :
ISP :
TL-R470T+ Load Balance Stop Working after 3 Days
I didn't change any settings it just refust to pull anything from WAN2.. I Swapped and it didn't want to pull from WAN1..
All my settings are static since I'm pulling from over a WiFi WAN
The only settings I put into the router was the 2 WAN Addresses and Adance>Load Balance Take the Tick Off Enable Application Optimized Routing