multicast flooding
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
multicast flooding
Region : Australia
Model : TL-SG2424
Hardware Version : V1
Firmware Version :
ISP :
i have just setup one of these switches and cannot get the multicast table to populate ip addresses and the setop boxes connected to the network are flooding.
i have an ip server outputting 24 streams with a total output bandwidth of 320Mbs and 9 setop boxes requesting the individual streams, i have set this system up before several times using cisco/linksys switches with L3 capabilities with only a few teething issues on setup.
i have been told by others this switch i am trying to setup will not do L3 yet the documentation states it does comply to this spec.
I have set up the following parameters:
created VLAN 2
multicast on
igmp on
but i cannot see anywhere to set the L3 parameters.
Model : TL-SG2424
Hardware Version : V1
Firmware Version :
ISP :
i have just setup one of these switches and cannot get the multicast table to populate ip addresses and the setop boxes connected to the network are flooding.
i have an ip server outputting 24 streams with a total output bandwidth of 320Mbs and 9 setop boxes requesting the individual streams, i have set this system up before several times using cisco/linksys switches with L3 capabilities with only a few teething issues on setup.
i have been told by others this switch i am trying to setup will not do L3 yet the documentation states it does comply to this spec.
I have set up the following parameters:
created VLAN 2
multicast on
igmp on
but i cannot see anywhere to set the L3 parameters.