Have power and LAN but no wireless signal strength lights

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Have power and LAN but no wireless signal strength lights

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Have power and LAN but no wireless signal strength lights
Have power and LAN but no wireless signal strength lights
2014-06-08 23:58:16
Region : UnitedStates

Model : TL-WA5210G

Hardware Version : V2

Firmware Version :

ISP :


The power and LAN lights on the WA5210G are on, but the signal-strength lights are not. Resetting the unit causes the high signal-strength light to blink, then all four to light up and shine steadily for a second or two, then all to go out. The device can't be configured, as there is no wireless contact. Is this a bad unit, or what can be done?
  0      
  0      
#1
Options
1 Reply
Same problem
2014-06-18 04:24:42
I have the same issue. Is there a simple guide to *every setting* I need to change to start the unit as a simple WAP?
  0  
  0  
#3
Options