TL-R470T+ Virtual Server not working by Link Backup
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-R470T+ Virtual Server not working by Link Backup
Region : Argentina
Model : TL-R470T+
Hardware Version : V4
Firmware Version :
ISP :
Hello,
I have 2 WANs. WAN1 is preferred and WAN2 should be only backup in case of WAN1´s failure. I set Load Balance-Link Backup. The backup works fine but all my existing virtual servers on WAN1 stopped working. Is there any solution to solve that? Without Link Backup the WAN1 and WAN2 are used for connections.
Thanks,
Radek
Model : TL-R470T+
Hardware Version : V4
Firmware Version :
ISP :
Hello,
I have 2 WANs. WAN1 is preferred and WAN2 should be only backup in case of WAN1´s failure. I set Load Balance-Link Backup. The backup works fine but all my existing virtual servers on WAN1 stopped working. Is there any solution to solve that? Without Link Backup the WAN1 and WAN2 are used for connections.
Thanks,
Radek
