TL-SG105E Management VLAN for switch's dhcp client
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-SG105E Management VLAN for switch's dhcp client
Hardware Version : V1
Firmware Version : Most recent
I am trying to setup the SG105E using its built-in DHCP client.
During testing, using 802.1q to partition the switch into 5 separate VLAN domains (one per port),
it seems the switch will broadcast a dhcp address request for itself on any of the five ports.
There does not seem to be a way to limit the request to a specific VLAN.
If each VLAN had its own dhcp server, this would cause all the dhcp servers to respond to the request.
What seems to be missing is a VLAN management ID.
Any ideas?
Firmware Version : Most recent
I am trying to setup the SG105E using its built-in DHCP client.
During testing, using 802.1q to partition the switch into 5 separate VLAN domains (one per port),
it seems the switch will broadcast a dhcp address request for itself on any of the five ports.
There does not seem to be a way to limit the request to a specific VLAN.
If each VLAN had its own dhcp server, this would cause all the dhcp servers to respond to the request.
What seems to be missing is a VLAN management ID.
Any ideas?