SG108E - removing ports from VLAN1
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
SG108E - removing ports from VLAN1
Model :
Hardware Version : Not Clear
Firmware Version :
ISP :
I'm setting up an SG108E to replace a failed HP Switch.
It seems VLAN1 spans all ports, untagged, by default and that there's no way to change that behavior.
If I define a VLAN and make a port a member of that VLAN (and also set the port's PVID), broadcast traffic from VLAN1 still goes out of that port. Not the desired result; it's not true 'isolation' - I want the port to only pass traffic within its own VLAN and nothing else.
Am I missing something here? Why can't I remove VLAN1 from some ports?
Thanks!
Hardware Version : Not Clear
Firmware Version :
ISP :
I'm setting up an SG108E to replace a failed HP Switch.
It seems VLAN1 spans all ports, untagged, by default and that there's no way to change that behavior.
If I define a VLAN and make a port a member of that VLAN (and also set the port's PVID), broadcast traffic from VLAN1 still goes out of that port. Not the desired result; it's not true 'isolation' - I want the port to only pass traffic within its own VLAN and nothing else.
Am I missing something here? Why can't I remove VLAN1 from some ports?
Thanks!