Route all traffic through ipsec VPN with TL-R600VPN
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Route all traffic through ipsec VPN with TL-R600VPN
Model :
Hardware Version : Not Clear
Firmware Version :
ISP :
I am using a TL-R600VPN as an endpoint for a small office. I have the site-to-site setup and working properly for the specified networks, but I want to route all traffic from the remote site (using theTL-R600VPN) though the VPN connection to the main site. I tried to add a route for 0.0.0.0 but receive an error "Error code: 4001. Bad destination IP address, please input another one." How do I direct all outbound traffic to the remote vpn site (and the remote site will route traffic to the internet as needed)?
Remote Site ->> TL-R600VPN --> Site-To-Site VPN --> Main Site VPN --> Internet
Hardware Version : Not Clear
Firmware Version :
ISP :
I am using a TL-R600VPN as an endpoint for a small office. I have the site-to-site setup and working properly for the specified networks, but I want to route all traffic from the remote site (using theTL-R600VPN) though the VPN connection to the main site. I tried to add a route for 0.0.0.0 but receive an error "Error code: 4001. Bad destination IP address, please input another one." How do I direct all outbound traffic to the remote vpn site (and the remote site will route traffic to the internet as needed)?
Remote Site ->> TL-R600VPN --> Site-To-Site VPN --> Main Site VPN --> Internet
