Switch suddenly disconnected
Hey there,
one of my switches suddenly changed its status to "DISCONNECTED" and is no longer accessible.
It is a SG3210X-M2 v1.0 - not SG3210XHP-M2 v1.0 - but was not selectable in the list.
The switch LEDs on the switch seem to be fine. Power is lit, Sys is blinking and uplink is 10 Gbit/s.
The switch it is connected to also says that it has a 10 GBit/s connection to the prolematic switch.
So physically everything should be fine.
What can I do to get the switch back online? I already tried to force reprovisioning but this did not help.
Thanks in advance!
GaRv3
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
I had to factory reset, adopt and reconfigure it.
Things like this MUST NOT HAPPEN on enterprise level products!
- Copy Link
- Report Inappropriate Content
Thank you for your post. There can be many reasons why a switch disconnects. When it goes offline, can you run a ping test to verify connectivity between the switch and the Controller? In addition to resetting and re-adopting the switch to restore it, does simply rebooting the switch bring it back online when it disconnects?
You should also check the Controller for any logs that might indicate why the disconnection occurred. Furthermore, is this disconnection happening frequently, or is it only an occasional issue? If it’s frequent, roughly how often does it occur? When the problem arises, is the traffic on the devices connected to this switch still normal?
The next time this happens, after rebooting the switch to restore connectivity, please export the device-info file for us so we can perform an initial analysis.
- Copy Link
- Report Inappropriate Content
This happened once - presumably after a power outage. The logs just said that it disconnected.
Rebooting the switch did not help. This was - of course - one of the first things I tried.
I did actually download the device info. Can I post it here or does it contain any private information and should be sent via PM?
- Copy Link
- Report Inappropriate Content
Since you already reset the device when the incident occurred, the Device Info should contain no logs, so we are unable to determine what caused the previous issue. Please keep monitoring; if it happens again, contact us and we can follow up through a support ticket.
- Copy Link
- Report Inappropriate Content
@Ethan-TP I downloaded the device info BEFORE the reset - of course
- Copy Link
- Report Inappropriate Content
Thank you so much for taking the time to post the issue on the TP-Link community!
To better assist you, I've created a support ticket via your registered email address and escalated it to our support engineer to look into the issue. The ticket ID is TKID250923778, please check your email box and ensure the support email is well received. Thanks!
Once the issue is addressed or resolved, welcome to update this topic thread with your solution to help others who may encounter the same issue as you did.
Many thanks for your great cooperation and patience!
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 249
Replies: 6
Voters 0
No one has voted for it yet.