Cluster Setup Issue – IP Configuration Error on Secondary Node

Cluster Setup Issue – IP Configuration Error on Secondary Node

Cluster Setup Issue – IP Configuration Error on Secondary Node
Cluster Setup Issue – IP Configuration Error on Secondary Node
10 hours ago
Hardware Version: V6
Firmware Version: 6.0.0.23

Cluster Setup Issue – IP Configuration Error on Secondary Node

Hello TP-Link Team,

I'm currently trying to configure an Omada Controller Cluster using the official guide:
🔗 https://www.tp-link.com/br/support/faq/4348/

🖥️ My Setup

Primary OC Software:

  • WAN IP: 143.0.0.127 (behind NAT → 192.168.0.2)

Secondary OC Software:

  • WAN IP: 177.153.20.155 (no NAT, public IP directly assigned)

 

⚙️ Issue

When I start the cluster, the Primary Node shows as Connected successfully.
However, the Secondary Node fails to join and displays an “IP configuration error”, asking to review the IP settings.

 

🔍 Troubleshooting Done

I suspected it could be related to the ISP or some firewall rule (Firewalld/CSF), so I tested again in a local environment:

  • Primary: LAN IP 192.168.0.2

  • Secondary: LAN IP 192.168.0.8

In this test, the Primary Node starts normally, but when the Secondary Node tries to start, it still shows the same “IP configuration error”.

 

❓ Questions

Could this issue be related to:

  • The use of NAT on the primary node (public IP ≠ LAN IP)?

  • The IP detection mechanism of Omada not handling NATed or mixed network setups correctly?

  • Or a missing configuration in omada_distributed_internal_mongo_cluster.properties or system.properties to support this scenario?

 

💬 Request

Any guidance, tips, or example configuration (especially when one node is behind NAT) would be greatly appreciated.

Thanks in advance! 🙏

  0      
  0      
#1
Options

Information

Helpful: 0

Views: 21

Replies: 0