I finally got around to upgrading the firmware of my EAP211s since the Omada controller has a bug and thought the v1.0.0 2024 firmware was up to date. I upgraded from 1.0.0 to 1.1.2 to 1.1.3 as suggested in the directions.

No other settings were changed, radio settings were at Auto. I even cycled through all the channels manually to see if I could get the better signal back. The Auto power has a setting of 25 for both.

Is this normal with all the changes made in the firmware from 1.0.0 to 1.1.3? I unfortunately can't reverse the firmware now.

I also did a speed test and only got about 200Mbps both ways on channel 44, sometimes less. When I change it to channel 153 I get about 330Mbps one way and about 170Mbps the other. I couldn't do any speed tests before the firmware upgrade, since that option wasn't added to v1.0.0 yet.

The bridges are about 100 feet apart with no obstructions. One of them might be just a little bit pointing to the side, but really they're just about pointing at each other and are at about the same height, top of chimney height.

Are there any settings I should look at to change?