TL-R480T+ Vlan
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-R480T+ Vlan
Model :
Hardware Version : Not Clear
Firmware Version :
ISP :
Good morning,
I have to configure a router TL-R480T + in order to get three subnetworks independent of each other, but using the same router as the default gateway.
Should I use the parameter VLAN1, VLAN2, etc.?
other configurations are required? eg Multi-Nets NAT?
all three subnets should have the same class of addresses (eg 192.168.0.1) or three different subnets? (192.168.0, 192.168.1.x, etc.)
Thank you.
Luca
TL-R480T+ v.7
Hardware Version : Not Clear
Firmware Version :
ISP :
Good morning,
I have to configure a router TL-R480T + in order to get three subnetworks independent of each other, but using the same router as the default gateway.
Should I use the parameter VLAN1, VLAN2, etc.?
other configurations are required? eg Multi-Nets NAT?
all three subnets should have the same class of addresses (eg 192.168.0.1) or three different subnets? (192.168.0, 192.168.1.x, etc.)
Thank you.
Luca
TL-R480T+ v.7