Siemens Logo!( and TP-Link Pharos CPE510
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Siemens Logo!( and TP-Link Pharos CPE510
Model :
Hardware Version : Not Clear
Firmware Version :
ISP :
Hallo,
I am searching a solution for the following problem. I have a Siemens Logo! 8 device with an ethernet RJ45-port. With the direct connection to a computer I can look over an web-interface into the Siemens device. Now I want connect 2 TP-Link Pharos CPE510 devices, one direct near the Siemens Logo!8 device and one in an office (150m) away connected to an router with internet connection. Is is possible to work with this constallation and how is the setup for the 2 TP-Link Pharos CPE510 devices? Thank´s very much for your help.
Best regards
ZI2016
Hardware Version : Not Clear
Firmware Version :
ISP :
Hallo,
I am searching a solution for the following problem. I have a Siemens Logo! 8 device with an ethernet RJ45-port. With the direct connection to a computer I can look over an web-interface into the Siemens device. Now I want connect 2 TP-Link Pharos CPE510 devices, one direct near the Siemens Logo!8 device and one in an office (150m) away connected to an router with internet connection. Is is possible to work with this constallation and how is the setup for the 2 TP-Link Pharos CPE510 devices? Thank´s very much for your help.
Best regards
ZI2016
