Communicate Between 2 different networks
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Communicate Between 2 different networks
Model : R480t+
Hardware Version :
Firmware Version :
ISP : FiberLink
Please help me to sort out how to communicate between 2 different networks.
i am using Load Balancer R480t+ as a internet Gateway.
Networks are
R480t+= 192.169.4.0
cisco e900 wifi router connected via r480t+ using wan and
Cisco e900 lan network= 192.169.2.0
i cannot ping 192.169.4.0 to 192.169.2.0 but 192.169.2.0 can ping to 192.169.4.0
Note: The lan connected directly through r480t+ lan ports use pppoe service while e900 thier wan ip is excluded in r480t+ pppoe services and e900 get ip through dhcp from r480t+.
I am not using any smart managed switch only R480t+ is using.
Hardware Version :
| TL-R480T+ v7.0 |
Firmware Version :
| 1.0.0 Build 20141208 Rel.36351s |
ISP : FiberLink
Please help me to sort out how to communicate between 2 different networks.
i am using Load Balancer R480t+ as a internet Gateway.
Networks are
R480t+= 192.169.4.0
cisco e900 wifi router connected via r480t+ using wan and
Cisco e900 lan network= 192.169.2.0
i cannot ping 192.169.4.0 to 192.169.2.0 but 192.169.2.0 can ping to 192.169.4.0
Note: The lan connected directly through r480t+ lan ports use pppoe service while e900 thier wan ip is excluded in r480t+ pppoe services and e900 get ip through dhcp from r480t+.
I am not using any smart managed switch only R480t+ is using.
