Model :

Hardware Version :

Firmware Version :

ISP :

Hello!


I tried to configure an 802.1q VLAN on an TL -SG 1024 Switch.


(First I red all TP-Link tutorials about VLAN configuration.)


The switch (Switch no.1) is directly connected to main router at Port 4 (Internet) and provides internet to devices from main network.
Also the switch is connected to other switch through Port 2 (which is set as Trunk and tagged - this may be not important because my VLAN is set only on Switch no.1).


My VLAN uses Port 12.


The purpose of this VLAN:At Port 12 is connected another router (TP-Link 841) which creates a subnetwork.This router is used only for wireless users.The wireless users must access Internet but must not scan the main network or ping an device from main network.
For this purpose I set VLANS as follows:
VLAN 1:default. Ports 1-24 untagged.
VLAN 2:Internet: Port 2:Tagged ,Ports 1,3-24 Untagged . Created to allow devices from VLANS to connect to Internet.
VLAN 8 (for my purpose) :Port 4 (Internet),Port 12 (wireless subnetwork router) Both ports untagged.
PVID :Port 4:PVID=2 ,Port 12:PVID=8 , Port 2 (Trunk) :PVID = 1 ,Other Ports which don't belong to other VLANS :PVID = 1.


After configuration I connected a laptop to my wireless network and made a network mapping.
I see the shares and devices from main network and even the ping to a device from main network was succesful.The VLAN didn't work.


What was wrong?


Thank You.