Internet <-> CPE210 ))) ((( CPE210 <-> Host ... Bridging problem. Paketloss 2%
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Internet <-> CPE210 ))) ((( CPE210 <-> Host ... Bridging problem. Paketloss 2%
Model :
Hardware Version :
Firmware Version :
ISP :
Hello guys,
i got the configuration here:
Internet <-> CPE210 ))) ((( CPE210 <-> Host
The CPE on the WAN side is the AP the other CPE on the host side is in set as bridge.
I got the problem that i got 2% paketloss on the WAN CPE side.
The CPE210 on the host side is without failures so far i could see with ifconfig.
In ifconfig i could see that the error counter is getting up and up.
The distance is 50M i got set both to 5 dbm power with MaxTream enabled and set to Auto.
There is a WPA2 configured and the link is up with 270 - 300 Mbit/s.
The link has 40 dbm SNR in both directions.
Im not sure what i could do to eliminate the 2% paketloss.
Its not my figure but with Ubiquiti there was 0,02% paketloss.
Any advises here ?
Regards,
Snot
Hardware Version :
Firmware Version :
ISP :
Hello guys,
i got the configuration here:
Internet <-> CPE210 ))) ((( CPE210 <-> Host
The CPE on the WAN side is the AP the other CPE on the host side is in set as bridge.
I got the problem that i got 2% paketloss on the WAN CPE side.
The CPE210 on the host side is without failures so far i could see with ifconfig.
In ifconfig i could see that the error counter is getting up and up.
The distance is 50M i got set both to 5 dbm power with MaxTream enabled and set to Auto.
There is a WPA2 configured and the link is up with 270 - 300 Mbit/s.
The link has 40 dbm SNR in both directions.
Im not sure what i could do to eliminate the 2% paketloss.
Its not my figure but with Ubiquiti there was 0,02% paketloss.
Any advises here ?
Regards,
Snot