WBS210 (v1.20) with external omni directional antenna.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
WBS210 (v1.20) with external omni directional antenna.
Model : WBS210
Hardware Version :
Firmware Version : 1.3.3 Build 20160705 Rel. 52453
ISP :
Hello.
I got an WBS210 with 2 omni directional antennas on it at 6dbi. I want to use it in client mode.I have great signal at my mane AP, but i have a lot of probles with WBS210.
When im connected to the AP sometimes i have probles with ip address ,others with the DNS and sometimes it stops working propertly.
So i have to resset to factory and reconect but the problem doesn't solve and i have to resset it multiple times to get it work again.
When it work propertly i have very good internet but i only have available 3 ip adresses.Don't know why....
An other thing that i noticed is that i have very low RX Rate and very high TX Rate...when the RX and TX is balanced i have very slow internet.
I hope that it's something on the setings that i'm doing wrong.
Any suggestions?
Sorry for the bad Inglish
Hardware Version :
Firmware Version : 1.3.3 Build 20160705 Rel. 52453
ISP :
Hello.
I got an WBS210 with 2 omni directional antennas on it at 6dbi. I want to use it in client mode.I have great signal at my mane AP, but i have a lot of probles with WBS210.
When im connected to the AP sometimes i have probles with ip address ,others with the DNS and sometimes it stops working propertly.
So i have to resset to factory and reconect but the problem doesn't solve and i have to resset it multiple times to get it work again.
When it work propertly i have very good internet but i only have available 3 ip adresses.Don't know why....
An other thing that i noticed is that i have very low RX Rate and very high TX Rate...when the RX and TX is balanced i have very slow internet.
I hope that it's something on the setings that i'm doing wrong.
Any suggestions?
Sorry for the bad Inglish
