EAP Controller in AWS Wont pick up APs
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP Controller in AWS Wont pick up APs
Model : EAP110
Hardware Version :
Firmware Version :
ISP :
Hi all, some advise, please. I have read and re-red the FAQ http://www.tp-link.com/en/faq-913.html and watched the youtube video https://www.youtube.com/watch?v=eTLqcPt19Sc several times and all goes well after the APs (3x EAP 110) are discovered, then I use Batch Settings to assign the elastic IP and the Discover Utility indicates that Setting Succeed on all three, however they don't appear as Pending in the EAP Controller software running on AWS. I have had them setup previously in EAP Controller software running on a lappie but I reset them to shift to the EAP controller in the cloud. I have done and re done several times but no go???? Any ideas .... Please :-) Regards, Mick
Hardware Version :
Firmware Version :
ISP :
Hi all, some advise, please. I have read and re-red the FAQ http://www.tp-link.com/en/faq-913.html and watched the youtube video https://www.youtube.com/watch?v=eTLqcPt19Sc several times and all goes well after the APs (3x EAP 110) are discovered, then I use Batch Settings to assign the elastic IP and the Discover Utility indicates that Setting Succeed on all three, however they don't appear as Pending in the EAP Controller software running on AWS. I have had them setup previously in EAP Controller software running on a lappie but I reset them to shift to the EAP controller in the cloud. I have done and re done several times but no go???? Any ideas .... Please :-) Regards, Mick
