TL-R480T+ - Multi-Nets NAT question.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-R480T+ - Multi-Nets NAT question.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-R480T+ - Multi-Nets NAT question.
TL-R480T+ - Multi-Nets NAT question.
2017-03-21 19:50:59 - last edited 2021-08-21 06:06:51
Model :

Hardware Version :

Firmware Version :

ISP :



Can someone confirm TL-R480T+ support the following function with Multi-Nets NAT and Load Balance ?.

LAN users access Server network+ internet over WAN1 (connected to a p2p link only routing enabled), NAT must NOT be enabled for WAN1.
Direct Broadband with ppoe is connected to WAN2, NAT must be enabled.

When WAN1 link is down, it should automatically failover to WAN2 and users access the internet thru broadband.

Thanks,
  0      
  0      
#1
Options
1 Reply
Re:TL-R480T+ - Multi-Nets NAT question.
2017-04-06 09:21:03 - last edited 2021-08-21 06:06:51
LAN users access Server network+ internet over WAN1 (connected to a p2p link only routing enabled), NAT must NOT be enabled for WAN1.
Direct Broadband with ppoe is connected to WAN2, NAT must be enabled.

For the NAT disable, I think maybe one to one NAT can support this, and the NAT enable must be OK.

When WAN1 link is down, it should automatically failover to WAN2 and users access the internet thru broadband.

This can be achieved by the function link backup.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 933

Replies: 1

Related Articles