CPE-210 LAN1 Passive POE Passthrough
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
CPE-210 LAN1 Passive POE Passthrough
Model :
Hardware Version :
Firmware Version :
ISP :
Hi from new users :)
My question is about the possibility to hanging 2 passive PoE device with different subnet (and different brand/model) using Passive Poe Passthrough function of CPE-210 on LAN! port?
On the roof I have 2 CPE:
[A] (unknow brand) CPE (192.168.1.1) provided by my WISP (internet connection)
[B] TPLINK CPE-210 (192.168.0.254) used in AP mode to give wireless connection for outside
May connect and power CPE [A] using LAN1 port of CPE-210 [B] even they are in different subnet just to use a single data/power cable for both devices?
Many thanks and sorry for english mistakes
internet-CPE[A] 192.168.1.1
|
>ROUTER for Office wired connection
|
>CPE-210 [B] for outside wireless connection 192.168.0.254
Hardware Version :
Firmware Version :
ISP :
Hi from new users :)
My question is about the possibility to hanging 2 passive PoE device with different subnet (and different brand/model) using Passive Poe Passthrough function of CPE-210 on LAN! port?
On the roof I have 2 CPE:
[A] (unknow brand) CPE (192.168.1.1) provided by my WISP (internet connection)
[B] TPLINK CPE-210 (192.168.0.254) used in AP mode to give wireless connection for outside
May connect and power CPE [A] using LAN1 port of CPE-210 [B] even they are in different subnet just to use a single data/power cable for both devices?
Many thanks and sorry for english mistakes
internet-CPE[A] 192.168.1.1
|
>ROUTER for Office wired connection
|
>CPE-210 [B] for outside wireless connection 192.168.0.254
