T2600G-28TS: newbie question on managed switch
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
T2600G-28TS: newbie question on managed switch
Model :
Hardware Version :
Firmware Version :
ISP :
sorry for misusing this expert forum for newbie's questions!
I just received my new T2600G-28TS. I connected it behind my access-router. I amanged to assign a different device IP-address (according to my router-IP-address) (I did that in Routing-InterfaceList-VLAN1) and did a formware upgrade.
So far so good.
When trying to get NTP administrated or doing a ping-out (Maintenance-NetworkDiagnosePing), that doesnt work. Seems like the basic configuration is blocking all out-going traffic.
On my small switch TL-SG108E it was easy and the basic configuration let the managed switch just start working as an un-managed one.....
How can I get the T2600G work like an un-managed switch to start with? :confused:
Bernd
Hardware Version :
Firmware Version :
ISP :
sorry for misusing this expert forum for newbie's questions!
I just received my new T2600G-28TS. I connected it behind my access-router. I amanged to assign a different device IP-address (according to my router-IP-address) (I did that in Routing-InterfaceList-VLAN1) and did a formware upgrade.
So far so good.
When trying to get NTP administrated or doing a ping-out (Maintenance-NetworkDiagnosePing), that doesnt work. Seems like the basic configuration is blocking all out-going traffic.
On my small switch TL-SG108E it was easy and the basic configuration let the managed switch just start working as an un-managed one.....
How can I get the T2600G work like an un-managed switch to start with? :confused:
Bernd
