Model :

Hardware Version :

Firmware Version :

ISP :

Hello !

I have some SG3109 switchs which are monitoed to its known MAC addresses. This works, just as an example, using linux snmpwalk command, like this:
>snmpwalk -v 2c -c public 192.168.1.2 .1.3.6.1.2.1.17.4.3
and one can even pick the mac addresses directly.

Astounding for me, querying the bigger switches I have in use (SG3216) , which I bought later (some time after the SG3109) fails!
Does that mean, the snmp bridge MIB is not supported on this switch?
What so about the TL1600 - which is probably my next candidate.

But from a security perspective, a LAN has to be watched for foreign addresses and so I hasitate to buy a new switch from
TP-LINK, because I am unable to find the reason:
- not supported ??
- how to configure the switch to access this OID: .1.3.6.1.2.1.17.4.3

Thanks anyway,
Manfred

Note: There are several "standards" to this, see: http://cric.grenoble.cnrs.fr/Administrateurs/Outils/MIBS/?oid=1.3.6.1.2.1.4.22
- IP-MIB (CISCO)
- RFC1213-MIB (DELL)
- IP-MIB (DELL)
- IP-MIB (ietf)
- RFC1213-MIB (ietf)