Redundant Setup with CPE510
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Redundant Setup with CPE510
Model :
Hardware Version :
Firmware Version :
ISP :
Hi there,
we are already using a bridge with two CPE510s and wanted to install a seperated second bridge for redundancy.
We also wanted to have the two lines working together, sort of trunked.. and if one fails that all the traffic should use the other bridge only.
Is there a way to set this up inside PharOS? Or do we have to configure the Switchports themselves?
Greetings,
nokut
Hardware Version :
Firmware Version :
ISP :
Hi there,
we are already using a bridge with two CPE510s and wanted to install a seperated second bridge for redundancy.
We also wanted to have the two lines working together, sort of trunked.. and if one fails that all the traffic should use the other bridge only.
Is there a way to set this up inside PharOS? Or do we have to configure the Switchports themselves?
Greetings,
nokut
