Model :

Hardware Version :

Firmware Version :

ISP :

Gentlemen,
I do have two CPE and my intention is to of course to extend my network. Situation looks as follows:
In one end I have a fiberoptic modem and I want to connect one CPE to this modem.
In the other end I want to use the other CPE and connect that one to a switch.

The reason for this set up is that we do have IPTV that can't run via the router, I need to pass on the
same range of IP-addresses that are coming out of the modem and these addresses do change from
time to time.

Question:
How do I configure my CPE's to have the TPport on the second CPE looking the same as the TPport
on my fiberoptic modem???