@Fae My OC200 will never come up in recovery mode. I disable my security software Plug my PC directly into Eth2 Configure my IP settings as specified Press and hold the reset button, then plug up the...

@Somnus I've got a ticket in, just waiting and trying to figure it out on my own in the meantime. Probably just going to have to go back to a software controller until I can get rid of this whole...

@Emitplink Thanks, I'll give that a try if I can get my controller back running. Does that actually allow for direct login with the device, or does that simply disconnect it from this Controller but...

Is there any guidance to removing devices from being controlled by the Omada Controller, or is the only option to perform a factory reset on any of the equipment you want to disconnect?

I let it sit for a few hours and was able to directly access the setup page again. Went through the initial setup, got into the app, restored a configuration backup, and now its unusable again. I'm...

Have had my OC200 running for 6 months without any real issues other than just software quirks. A few days ago the power went out to the house briefly, then when it came back up I could not reach the...