@herman12 this is incorrect, the issue in the OP was a bug, and it was resolved in the official 6.1 controller release - you are again free to make a reservation on any IP withing the whole scope of...

@HarmonJA OC200 does have IP Group management page I have many switches including a 2428P, many switch ACLs, and many rules with an IP-Port group destination and i dont have any widespread issues...

@doublemac Before Controller 5.15 and corresponding gateway firmware, you could block GMP from VPN users with this rule (as you did, although you only need TCP) WAN IN > Block > [TCP] [IPGroup] > GMP...

@Hank21 Im not sure where you got this information, but this does not occur at all on any form of VPN on a controller managed network....

@URL You set up VLANs and assign the gateway an IP address on each one with corresponding DHCP server, then you change the gateway ports to be native to whichever vlan you want them on. After that,...

@Vishlamba If you have DPI / Application Control enabled this will impact throughput significantly as every single packet is being examined by the DPI engine. Otherwise, i have achieved full 1gig...