KimcheeGUNLV4Offline
Following: 5Followers: 5
Forums/ Gateways
2022-07-06 17:59:10
Re:ER605 v1 WAN port assigns itself 192.168.100.11
So quick question... is your WANs coming from two separate Internet connections? Or are you trying to load balance from the same ISP? For example, some cable modems have 2 network ports on them. Are...
0HELPFULS
Forums/ Wireless
2022-07-06 13:46:22
Re:Network PING higher when create SSID with different VLAN
@Adam61 By chance is Air Time Fairness turned off? Also, is Your AP's completely updated to the newest firmware version? Are the 2 VLANs going in the same direction? Maybe one is bypassing the...
0HELPFULS
Forums/ Requests & Suggestions
2022-07-06 13:22:30
Re:DPI or IPS on the RoadMAP?
Thanks dude! I already have the device and I like it. Theres a few things I'd wish was there. DPI and even a small sub group for IPS.
2HELPFULS
Forums/ Wireless
2022-07-05 17:28:25
Re:Will this design support fast roaming?
Before you do... I would do a wireless site survey to see if you have enough signal between APs. Ghetto way: Configure your 1st AP and fire it up. Load Acrylic Home wireless Analyzer on your Laptop....
0HELPFULS
Forums/ Requests & Suggestions
2022-07-05 15:19:18
DPI or IPS on the RoadMAP?
DPI on the roadmap for the ER7602? The data can still be offloaded to the hardware acceleration chip. A minimum version of IPS / Suricata on the roadmap? small select categories?
7HELPFULS
Forums/ Controllers
2022-07-05 15:05:42
Re:EAP235-WALL Too Many Association Timeouts
@GeorgeVoutsinos -75 is pretty low signal. Thats where you start having wireless issues. -85 is holding on by a thread. Im guessing, once you set it to -75, that kicks you into having dead spots. You...
0HELPFULS