@Eric-jones12 Regardless of the PBR setting the Failover should work if enabled. Thats in the Internet/WAN section of the controller.

@Dropbear You cant adopt two routers on 1 site. This is what I do is... power up the new router on your test bench> Log in with your laptop > Set the LAN to your production LAN scheme> Remove the old...

@KONMER How is the OC200 being powered? BY POE? DNS settings in the OC200 set properly?

@mackworth I have set it for all my remote sites and it runs great so far... I set it to run at 3am every morning. So far so good. No complaints.

@Shoresy I noticed if I hook my 670 up to a bummy switch... the 2.5G port has a hard time negotiating down to 1G and bottoms out at 100mbps. Once I plug it up to a managed switch, it negotiates to 1G...

@GregZaaa Gonna play devils advocate here... I have a few 605 out in the wild at remote offices with no issues. But they're all connected to the Omada controller though. To log into the GUI are you...