Forums/
Controllers
a week ago
@Vincent-TP Now I see this menu. I'm not very proud of myself as I specifically looked for it. This is exactly what I was after. Thank you very much for helping
0HELPFULS
Forums/
Controllers
a week ago
@Vincent-TP The first check I'm looking after, is about Channel frequency and bandwidth, TX power, in each radio band. Adding channel utilization to these values would be helpful though I'm yet...
0HELPFULS
Forums/
Controllers
a week ago
Hello, I often install AP in corridors and give each a sequential name like AP01, AP02, AP03. When looking a Device View, I can see the following columns: Name, IP address Status Model Version...
0HELPFULS
Forums/
Wireless
2 weeks ago
@Vincent-TP Maybe, a diagram separating RX, TX and Interferences would help people from mis-interpreting displayed figures. In my case, I'll change radio settings in 2.4 GHz band (selecting different...
0HELPFULS
Forums/
Wireless
2 weeks ago
@Vincent-TP Thanks for replying. My case share seems similar with the one referenced above. I'll post my replies there to make them more useful.
0HELPFULS
Forums/
Wireless
2 weeks ago
Hello, In a building in which 50 APs are installed, I looked at an AP stats (EAP653 with 11.3 firmware). I'm seeing that this AP : has a low usage (3% in RX, 1% in TX) in 5 GHz band has a high RX...
0HELPFULS