Hi @MantonL, are you able to type 00:00 into the field?

@Fabiuzz, did you try option 138? You just need to set and maintain the controller's IP in one place and any Omada device using DHCP (factory default is enabled) should announce itself to the...

Hi @HeathL, Even if the cable tests ok, it's probably the cable. You have one working connection, so swap the AP and the switch port of the working connection with the bad ones. If the link that fail...

@crispbytes, when a device converted to/from SDN controlled and standalone, ALL settings are reset. You cannot use both methods to manage an Omada device at the same time and there is not a...

@crispbytes, yes the Omada SDN UI is different than the UI that run natively (standalone) on the devices.

Hi @PP_, Not sure if this would cause the problem, but the interface's address is included in the DHCP range. Try setting the lower bound to 10.8.0.2 or higher. I'm actually surprised the UI even...