Hi @Todd2024, I wouldn't plug the EAP225 into the EAP215; no need to make an extra hop. Also, it's odd that your cable failed. Not sure what type of cable you had and the weather conditions there,...

@fw61 port speed edit are in L2 Features, Switching-Ports. Select (check) one or more ports then use the drop-down in the header to set it. Don't forget to click the save (upper right), otherwise...

Hi @fw61, You may need to adjust the speed/duplex settings on the SFP+ port used to match the client. I thought the ports were defaulted to 10G/Full, so if your client doesn't support that speed this...

@rhimbo, not 100% sure about arp working. Maybe a wireshark capture, if necessary. With the switch disconnected from all other devices and factory reset, it should be forced to use it's default...

Hi @AP813, It's probably just a misconfiguration in the AP's wifi. You could try changing the configuration on just the 2.4GHz band and connect using the 5GHz band to troubleshoot. Alternatively, if...

Hi @Paoiiiiiiiii27, Full instructions are linked below, but I think this is the part you need... Power on the switch and keep clicking the keyboard to stop autoboot, then you will enter the BootUtil...