Clive_A wrote @parhamsan parhamsan wrote Clive_A wrote @parhamsan parhamsan wrote @MR.S Hello, So here is what I did. I Forgot the ER8411 from the OC200 (the ER8411 got factory reset), enabled the...

MR.S wrote @parhamsan I don't think it matters, but my settings are like that. @MR.S Yep, confirmed both are working now on the 1.3.1 Firmware, the main issue was the NAT and port forwadring (for...

MR.S wrote @parhamsan did you disable NAT on Wireguard and OpenVPN? when it comes to OpenVPN, ACL works so if you have any ACL then try disabling this @MR.S Yep all NAT for WG and OVP are disbaled. I...

MR.S wrote @parhamsan I'm pretty sure it works with 1.3.1 so you probably don't need to downgrade again. @MR.S Thats odd, WG works but OpenVPN just stopped working!!! Have not changed any settings so...

MR.S wrote @parhamsan yes you are in the right place you type enable and then roll-back, but roll-back is a new command in the 1.3.1 firmware so you will not see it until you have upgraded. type ? to...

MR.S wrote @parhamsan It's hassle-free to upgrade, you downgrade without going stand-alone. You connect with SSH and downgrade with the roll-back command. @MR.S MR.S, How do you SSH into the router...