@MR.S So I configured the L2TP Client and changed from NAT to Route and I am now able to access the devices on the network remotely.

@MR.S Thanks, I will go through these.

@MR.S I am not able to ping. when I send a ping it says timeout instead of unreachable but no successful reply. If I have this correct, the ER605 would be the Server and the PC that I am connecting...

@MR.S no port forwarding was done. Yes, the L2TP works, It shows connected on the computer that I am connecting from and the router shows that the tunnel is active.

@MR.S I am using the TPLINK ER605 V2.6 Router in standalone mode to setup a L2TP VPN link to remotely access the resources on that network. I am specifically trying to eliminate the use of Anydesk...

Hello: Seeking some assistance to complete this setup. I am able to connect successfully but I am unable to see any of the hardware devices on the network. I have not configured any routes so I am...