Hi @Vincent-TP Please tell me when approximately we can expect this idea to be implemented?

Hi @Vincent-TP Beacon Control should be set up for 5GHz only? Or for 2.4GHz too?

Hi @MR.S I have the minimum settings: 2.4 & 5GHz (never enabled 6GHz), password, VLAN, 802.11r enabled and "802.11 Rate Control" enabled. I tried disabling 802.11 Rate Control - the situation does...

Good day to all. I encountered an incomprehensible problem. I have Omada Software Controller v5.15.20.21 and several EAP653 points with firmware v1.1.3. The controller has one Site configured, which...

Hi @Vincent-TP Yes, thank you, I didn't notice this setting. But perhaps, for convenience, it makes sense to make a single checkbox for disabling, because when using all three ranges (2.4/5/6 GHz)...

Hi everyone! It would be good if the developers added a function such as "disabling the point" to the controller functionality in the device management section. When the radio module of the point is...