Hi R1D2, Thanks for the help

Ah, yes.. this should be the problem.. no static routes are set. The switches actually reachable from the same subnet as management host is placed. So I have two interfaces one is in e.g...

R1D2 wrote Wait a moment: are you using the switch on the WAN side with a public IP? Maybe you can draw a picture of the network topology to make it more clear from which system you want to be able...

Hi R1D2, Thanks for the answere. I checked ACL section but no ACLs are in place. If I enable NAT on firewall's interface, the connection succeeds to GUI. When I set an Interface under Routing with...

Model : Hardware Version : Firmware Version : ISP : Hi All. I'd need help in the following: I have 3 switches mentioned in Title. I'd like to configure them to be managed through management vlan...